Activator Spray for CA Adhesives - 150 ml
Product no.: 83110
Description
Activator spray for CA adhesives - 150 ml
Item no .: 83110
This is a discontinued item because we have added new adhesives to our range. You can find them here!
By using the activator spray, the setting time of cyanoacrylate adhesives is considerably accelerated. The activator spray is used wherever an increased curing speed is required. Other areas of application are thick layers and absorbent substrates.
The activator spray is sprayed on from a spray distance of about 30 cm. Hand strength is achieved in 1-4 seconds, depending on the cyanoacrylate adhesive used, the gap between the parts and the room temperature. Attention: Can attack painted surfaces as well as PS and EPS rigid foams. A material test is recommended before use.
Can be stored for at least 12 months
Labeling according to Regulation (EC) 1272/2008
DANGER:
Contains: acetone.
Hazard warnings:
H222 Extremely flammable aerosol
H229 Pressurized container: may burst if heated.
H319 Causes serious eye irritation.
H336 May cause drowsiness and dizziness.
Safety instructions:
P102 Keep out of the reach of children.
P210 From heat, hot surfaces, sparks, open flames and other ignition sources. Do not smoke.
P211 Do not spray on an open flame or other ignition source.
P251 Do not pierce or burn, even after use.
P261 Avoid breathing aerosol.
P271 Use only outdoors or in a well-ventilated area.
P280 Wear eye / face protection.
P410 Protect from sunlight.
P412 Do not expose to temperatures exceeding 50 ° C / 122 ° F.
P337 + P313 If eye irritation persists: Get medical advice / attention.
Special marking:
EUH066 Repeated exposure may cause skin dryness or cracking.