AGAMA Hypersol 25ml - Strong Softener

AGAMA Hypersol 25ml - Strong Softener

Item no .: AG1472

For bubble-free application of decals, apply ADHESOL adhesion promoter to the substrate with a brush, slide on the decal and press on with a cotton swab. Use the cotton swab to gently roll out trapped air bubbles and excess liquid to the side. Then TENSOL softener (HYPERSOL on difficult substrates) is applied with a brush and allowed to dry for at least 12 hours. NEVER PRESS OR TOUCH AFTER APPLICATION, otherwise the decal will inevitably be destroyed and the lacquer will be loosened and damaged. If the decal has not completely clung to the surface after drying, repeat the process with HYPERSOL and allow it to dry again WITHOUT PRESSING AND TOUCHING.

Labeling according to Regulation (EC) 1272/2008

ATTENTION

Contains: butyl glycol (ethylene glycol monobutyl ether), ethanol

Hazard warnings:

H302 Harmful if swallowed.

H312 Harmful in contact with skin.

H315 Causes skin irritation.

Safety instructions:

P261 Avoid breathing aerosol.

P264 Wash hands thoroughly after handling.

P270 Do not eat, drink or smoke when using.

P271 Use only outdoors or in a well-ventilated area.

P280 Wear protective gloves.

P301 + P312 If swallowed: Call a poison center or doctor if you feel unwell.

P302 + P352 After skin contact: Wash with plenty of soap and water.

P304 + P340 If inhaled: Remove affected person to fresh air and ensure that they can breathe freely.

P305 + P351 + P338 If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if possible. Continue rinsing.

P330 rinse out mouth.

P332 + P313 If skin irritation occurs: Get medical advice / attention.

P337 + P313 If eye irritation persists: Get medical advice / attention.

P403 + P233 Keep container tightly closed in a well-ventilated place.

P501 Dispose of contents / container to in accordance with local / national regulations.

Special marking:

Keep out of the reach of children!